Harbor Freight Tools 65761 manual Packing the bearings, Hub and Wheel Assembly

Packing the bearings.

3.Using a suitable solvent, clean the bearings and the rest of the parts in the Hub assembly. The parts must be cleaned even if they are new or ap- pear clean.

4.Allow all pieces to dry completely.

5.Place fresh, clean bearing grease in the packer.

6.With the grease-filled bearing packer in one hand and the bearing in the other, press the bearing­ into the grease, forcing the grease inside the slots in the bearing, continue doing this until every slot in the bearing is completely full of grease.

Hub and Wheel Assembly

7.Put a Seal (59) and Bearing (49) on the Axle and then put the Tire (48) on the Axle.

8.With each Tire in place, add a Wash- er (50) and a Spindle Nut (51) onto the ends of the Axles. Tighten the Spindle Nuts to 20-25 ft. pounds and turn each tire several times to seat the bearing. Back off the Spindle Nut one half turn. Insert a Cotter Pin (25) through both the Axle and the Spindle Nut (51) and bend the end of the Pin back to hold it in place. Last, tap on a Wheel Cap (61).

Connecting the Rail Assembly to the Oil Tank

9.Insert the Front Leg Assembly (11) into the bracket on the Oil Tank As- sembly (10B). Insert the remaining Hex Head Bolt (16) through the hole in the middle of the bracket of the Oil Tank Assembly. Secure it with a Hex

Head Nut (17) and a Hex Head Bolt (16).

Note: When travelling, remove the Push Pin (26) and Hair Pin Clip (29) and lift the Front Leg Assembly up so that it is parallel to the Rail Assembly. Re- place the Push Pin (26) and Hair Pin Clip (29) into the Horizontal Transport Hole shown just above the Oil Plug.

10.To connect the Rail Assembly (2) to the Oil Tank Assembly, insert a Hex Head Bolt (16) into the middle hole of the “L” shaped bracket on the Oil

Tank Assembly. Secure it with a Hex Head Nut (17).

11.In FIGURES 1 and 2 (see next page), the Rail Assembly (2) is shown in Horizontal mode for opera­tion and travel (as mentioned above, the Front Leg Assembly (11) must be secured up in the horizontal position when travelling).

SKU 65761 For technical questions, please call 1-800-444-3353. Page 9