operate accidentally after the air supply is disconnected.
Note: Air flow, and therefore tool perfor- mance, can be hindered by under- sized air supply components.
2.The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.
3.Make sure the tool’s throttle or switch is in the off position; refer to Opera- tion section for description of con- trols.
4.Close the
5.Turn on the air compressor according to the manufacturer’s directions and allow it to build up pressure until it cycles off.
6.Adjust the air compressor’s output regulator so that the air output is enough to properly power the tool, but the output will not exceed the tool’s maximum air pressure at any time. Adjust the pressure gradually, while checking the air output gauge to set the right pressure range.
7.Inspect the air connections for leaks. Repair any leaks found.
8.If the tool will not be used at this time, turn off and detach the air sup- ply, safely discharge any residual air pressure, and release the throttle and/or turn the switch to its off posi- tion to prevent accidental operation.
Note: Residual air pressure should not be present after the tool is disconnected from the air supply. However, it is a good safety measure to attempt to
discharge the tool in a safe fashion after disconnecting to ensure that the tool is disconnected and not pow- ered.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect this Texture Spray Paint Gun before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury:
Do not adjust or tamper with any control or component in a way not specifically explained within this manual. Improper adjustment can result in tool failure or other serious hazards.
SKU 66103 | For technical questions, please call | Page 8 |
