Harbor Freight Tools 66103 Work Piece and Work Area Set Up, General Operating Instructions

Work Piece and Work Area Set Up

1.This Texture Paint Spray Gun is meant for spraying heavy viscos- ity products like rubberized decking materials, texture coatings for interior and exterior walls, heavy water proof- ing materials, and the like. It is not recommended for regular wall paint or thin coatings of any type. While these products can be used with this Spray Gun, the results would not be satisfactory, or even in coverage.

2.Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent injury and distraction.

3.Route the air hose along a safe route to reach the work area without creat- ing a tripping hazard or exposing the air hose to possible damage. The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.

4.There must not be utility lines or foreign objects nearby while working that may present a hazard.

General Operating Instructions

1.Attach the Plastic Hopper (20) to the top of the Gun Body (03) and tighten the Hopper Clip (21) until the Plastic Hopper is held securely in place.

2.Have an assistant pour the Texture Paint mix into the top of the Plastic

Hopper filling no more than 3/4 full.

3.Turn on the air compressor and set the air regulator between 25 and 90 PSI.

4.Using two hands, one to steady the Plastic Hopper and the other to oper- ate the Texture Paint Spray Gun, aim the Spray Gun Nozzle at the surface to be covered. NOTE: It may take a few times to mix the proper spray solution. Do not fill the Plastic

Hopper until you have achieved the viscosity you need for each job.

5.Squeeze the Gun Trigger (14) and move the Texture Paint Spray Gun in a back and forth motion, releasing the Gun Trigger at the end of each sweep.

6.If the product you are attempting to spray either sputters, or stops spray- ing, small adjustments in product control may be made using the Fluid Control Knob (8F), thinning the prod- uct batch you are working with, or us- ing a larger nozzle. NOTE: Nozzles can be interchanged by un-thread- ing the Nozzle attached to the Spray Gun Body and threading on a different sized Nozzle.

7.CAUTION: Do not stop for extended periods when spraying. Most of the products you are using are fast-dry materials and will start to set-up and dry as soon as they come in contact with the air. If you need to discon- tinue spraying for more than half an hour, turn off the air supply, discon- nect the Plastic Hopper from the Gun Body and thoroughly rinse the Plastic Hopper and Gun Body with fresh, clear, water. The products you are using can set-up quickly and if not cleared from your equipment may render that equipment unusable.

SKU 66103 For technical questions, please call 1-800-444-3353. Page 9