SAFETY
ASSEMBLY
Roof Cover (18) Installation
Note: Door and Back Covers (19, 20) not shown on illustrations to provide a clear view of installation.
1.Lay the Roof Cover (18) on the ground next to the frame. Make sure that the edges with black straps are alongside the Door/Back Covers (19,20) and one set of the fabric tubes is facing upwards, see Figure R.
2.Tie each Rope (21) through an eyelet at the corner of the Roof Cover.
3.Throw the other ends of the Ropes (21) over the frame.
4.Move to the other side of the frame and pull the Cover over the frame. Make sure that the Roof Cover is centred on the frame. If small adjustment is needed, two people should pull together from the same end of the Portable Garage so that the Roof Cover does not become twisted.
21 fabric 21
tube
18
Figure R: Pull Roof Cover (18) Over Frame using Ropes (21)
5.Insert the Bottom Rails into the fabric tubes on each side of the Roof Cover. Make sure the Bottom Rails are level and horizontal.
MAINTENANCE
| 4 |
4 | 21 |
|
Figure S: Insert Bottom Rails (4)
6.Attach the Bottom Rails (4) to the Corner Studs
11 | 11 | |
8 | ||
7 |
Note: Only finger tighten the Nuts (12) at this point.
13 | 13 | |
12 | ||
12 | ||
|
Figure T: 3 and 4-Way Rail Clamp (7, 8) Connections
7.Make sure that all the bottom cross rails are of the same height from the ground, then tighten all Nuts (12).
8.Secure the four corners to the Corner Legs (23) using Ratchet
Page 12 | For technical questions, please call | Item 69039 |