Harbor Freight Tools 69039 Stud, Foot, and Leg Assembly, 35-2, Figure E Roof Side Rail Assembly

3.Assemble a roof side rail using a 3‑Way Side Connector B (5-3), then three Rails (3) with

4-Way Side Connectors (6‑2) between them, and then a 3‑Way Side Connector A (5-2) on the far end. The Rails connect to the straight ends of the Connectors,

and the curved ends of all Connectors must face up angled the same direction, as shown. If that is not the case, incorrect connectors were used, or they were assembled backwards.

6-2

5-3

6-2

3

35-2

Figure E: Roof Side Rail Assembly

3

4.Assemble a second identical roof side rail by repeating the instructions in step #3.

5.Connect the roof side rail assemblies to the ends of the Rafters (2), as shown below.

2

		2	5-2
5-3
		2	6-2
		6-2	6-2	3
	3	6-2	2	5-3
		3	5-2

3

Figure F: Roof Side Rail Installation

6.Make sure all parts assembled up to this point are firmly joined together. Tap parts together gently with a rubber mallet (sold separately) if needed.

Stud, Foot, and Leg Assembly

1. Assemble a Foot (9) to the bottom of each Center Stud (1-1):

1-1	1-1
	15
9	16
	9
a. Place a Foot (9) onto the bottom	b. Align the holes and insert a
of the Center Stud (1‑1).	Pin (15) through them.
	1-2

2.Assemble a Corner Leg (23) to the bottom of each Corner Stud (1-2) as shown.

	1-1
15	16
	9

c.Insert a Cotter Pin (16) through the Pin, and spread end open.

Figure G: Corner Leg

Assembly

SAFETY

ASSEMBLY

MAINTENANCE

23

Item 69039 For technical questions, please call 1-800-444-3353. Page 7