9.Use the Hex Wrench and Screws (6) to fasten the tops of the Legs to the Table Top underside. See Figure I, right.
y fet Sa
Leg (4)
Hex
Wrench
(9)
Table
Top (1)
Setup
no rati Ope
ec
10.Use the Hex Wrench and Screws (13) to fasten the sides of the Legs to the Table Top underside. See Figure J, right.
Note: There are no pilot holes available for this step, so you will need to use a drill to make the pilot holes before threading in Screws.
11.Set the Lower Support (15) across the top of the Sliding Partition and against the sides of the Legs. Then use Screws (6) to fasten each end of the Lower Support to the sides of the Legs. See Figure K, right.
Figure I
Leg (4)
Table
Top (1)
Figure J
Lower
Support
(15)
Maintenan
Leg (4)
Screws (6)
Figure K
Page 6 | For technical questions, please call | Item 69054 |
