Harbor Freight Tools 91840, 91839, 92199 Assembly continued, For replacement parts, please call

Assembly (continued)

Connecting the Rail Assembly (2) to the Oil Tank Assembly (10B)

1.Insert the Front Leg Assembly (11) into the bracket on the Oil Tank Assembly (10B). Insert the remaining Hex Head Bolt (16) through the hole in the middle of the bracket of the Oil Tank Assembly (10B). Secure it with a Hex Head Nut (17). Refer to the Hex Head Nut (17) attached to the Hex Head Bolt (16) at the top of the Front Leg Assembly (11) in FIGURE 1 below. Note: When travelling, remove the Push Pin

(26) and Hair Pin Clip (29) and lift the Front Leg Assembly up so that it is parallel to the Rail Assembly (2). Then, replace the Push Pin (26) and Hair Pin Clip (29) into the Horizontal Transport Hole shown just above the Oil Plug (37), in FIGURES 1 and 2.

2.To connect the Rail Assembly (2) to the Oil Tank Assembly (10B), insert a Hex Head Bolt (16) into the middle hole of the “L” shaped bracket on the Oil Tank Assembly (10B). Secure it with a Hex Head Nut (17). Refer to the Hex Head Nut (17) attached to the Hex Head Bolt (16) just above the tire in FIGURE 1 below. Insert the Push Pin (26) through the hole, as shown in FIGURE 3.

3.In FIGURES 1 and 2, the Rail Assembly (2) is shown in Horizontal mode for opera- tion and travel (as mentioned above, the Front Leg Assembly (11) must be secured up in the horizontal position when travelling). For vertical operation see page 6.

FIGURE 1

Slide Assembly (3)

Safety Chain	Cylinder (1)
with Hook (4)

Base

Place Log Here

Hitch Coupler (9)

Hex Head Nut (17) is attached to Hex Head Bolt (16)

	Horizontal transport hole			Push Pin (26)	Rail Assembly (2)
					Vertical Position Hole
	Push Pin (26) and
	Hair Pin Clip (29)		Oil Plug (37)		Hex Head Nut (17) is
			with air inlet hole		attached to Hex Head Bolt
Front Leg Assembly (11)					(16)
					Vertical position
					locking hole
		Oil Removal Plug
	Oil Tank (10B)		Wheel Cap (61)

FIGURE 2

Horizontal transport hole

Close-up of Push Pin (26) securing the Front Leg Assembly (11) to the bracket on the Oil Tank Assembly (10B).

FIGURE 3

Second Push Pin (26) secures Rail Assembly (2), and is removed for vertical log splitting.

Air Inlet Hole

Push Pin (26)

Oil Plug (37) with air inlet hole

SKUs	91839, 91840	For replacement parts, please call 1-800-444-3353.	Page
	& 92199