Harbor Freight Tools 93507 See Figure Z, next SKU For technical questions, please call, Figure Y

5.To lubricate the Worm Gear and Worm Shaft: The Worm Gear (116) and Worm Shaft (203) run in an oil bath Gear Box (121) and should not require an oil change more than once a year, unless the oil becomes contaminated or a leak occurs due to improper replacement of the Gear Box Cover (114). To change oil in the Gear Box:

a.Position the Saw Arm in the horizontal position. (See Figure V.)

b.Remove the four Screws (112), Gear Box Cover (114), and Gear Box Gasket (115). (See Figure Y.)

c.Remove the old oil from inside the Gear Box (121) and replace the oil using 140 weight gear oil. The new oil should just come to the edge of the Gear Box. Do not overfill. (See Figure Y.)

d.Replace the Gear Box Gasket (115), Gear Box Cover (114), and four Screws (112). (See Figure Y.)

	GEAR BOX COVER	WORM SHAFT
(114)		(203)
SCREW		FIGURE Y		WORM GEAR
(112)			(116)

6.Periodically, remove the coolant Strainer (44) and brush any chips that may have accumulated away from the drain.

To replace the Coolant: The water-soluble Coolant should be replaced as often as is necessary to keep metal debris in the Coolant from clogging the hoses. To replace the Coolant:

a.Slide the Coolant Tank (107) out from under the Table (39) of the Bandsaw.

(See Figure Z, next page.)

SKU 93507 For technical questions, please call 1-800-444-3353. Page 27