SKU 93507 For technical questions, please call 1-800-444-3353. Page 23
MOTOR
TOGGLE SWITCh
(37)
COOLANT
PUMP VALVE
(159)
STOP BLOCK
(73)
POWER CORD
PLUG
(38)
hYDRAULIC
CYLINDER
(20)
SAW
BLADE
(127)
COOLANT PUMP
TOGGLE SWITCh
(11)
FIGURE V
SAW hEAD
6. Once all necessary adjustments to the Bandsaw have been made, plug the
Power Cord Plug (38) into the nearest 120 volt, grounded, electrical outlet (if
the Bandsaw is powered by a 120 volt system). If powered by a 230 volt system,
plug the Power Cord Plug into the nearest 230 volt, grounded, electrical outlet.
(See Figure V.)
7. Turn the Hydraulic Cylinder (20) to its “ON” position, and slowly allow the Saw
Head to lower until the Saw Blade (127) is just above the workpiece cut line. Turn
the hydraulic Cylinder back into its “OFF” position once it is in place.
(See Figure V.)
8. Turn the Coolant Pump Valve (159) to its “OPEN” position. Then, turn the Cool-
ant Pump Toggle Switch (11) to its “ON” position. (See Figure V.)
9. Turn the Motor Toggle Switch (37) to its “ON” position. (See Figure V.)
10. Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade
(127) tension or machine vibration. If this is found, turn off the Bandsaw and
correct the problem before using. (See Figure V.)
11. Allow the Saw Blade (127) to turn up to full speed before feeding the Saw Blade
(127) into the workpiece. (See Figure V.)
12. WARNING! Always keep hands and fingers safely away from the cutting
area.
13. Turn the Hydraulic Cylinder (20) to its “ON” position, and allow the Saw Arm to
REV 10/06