INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Make sure the Power Switch of the Engine is in its “OFF” position. Release all air pressure from the system and disconnect all tools and equipment from the Air Compressor before performing any inspection, mainte- nance, or cleaning procedures.
2.Before each use, inspect the general condition of the Air Compressor. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, loose air fittings, and any other condition that may affect the safe operation of the Compressor. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.Before each use, check the Engine oil level. If necessary, fill the crankcase of the Engine with the proper amount and type of engine oil. Refer to the Engine manufacturer’s manual for all inspection, maintenance, and cleaning in- structions.
4.Before each use, check the Air Compressor oil level. If necessary, fill with a premium quality,
5.Daily: Empty condensation from the Air Compressor’s Tanks (12). The Tanks should be emptied daily to release all trapped moisture that may cause Air Tank corrosion. Allow sufficient time for all of the condensation to escape from the Tanks. Then, firmly retighten the two Drain Plugs (25). (See Figure D.)
6.Every 500 hours or 12 months, replace the old compressor oil with new, pre- mium quality,
7.To replace the
BELT GUARD (13)
SCREW (21) |
|
|
| SCREW (21) |
|
|
SCREW (21)
SCREW (21)
FIGURE G
SCREW (21)
SKU 93874 | For technical questions, please call | Page 13 |
