Harbor Freight Tools 93920 manual Front Floor Plate View from above

(44) under the base and over the Bolt at each Floor Plate (16) connection. Use Long Bolts (60) for the Rear Brace (23) connections.

2.Attach the tops of the Rear Studs (8, 9, & 10) to the Rear-Right and Rear-Left Crown

	Beams (4, 5). For the Rear-Center Stud (10), use a 4		5
	Top Center Connector (39) to connect to the Crown
	Beams, as shown to the right.
3.	Refer to the Note in Figure C. Attach the two Side
	Studs (12) in the center of each side (without asterisks
	in Figure C) to the outside of the frame. Make the	10	39
	bottom connections using a Long Bolt (60) for later
	assembly of the Side Diagonal Brace (22). Slide a
	Hold-Down Connector (44) under the base and over the Long Bolt at each bottom
	connection, but do not install a Nut (61) over the Long Bolt yet.

4.Refer to the Note in Figure C. Attach the two Side Studs (12) near the corner of each side (with asterisks (*) in Figure C) to the outside of the frame. Slide a Long Bolt (60) into each slot for later Side Diagonal Brace (22) assembly. Slide a Hold- Down Connector (44) under the base and over the Bolt before installing the Nut (61) at each bottom connection.

5.Attach a Side Diagonal Brace (22) to the lower hole of a Corner Stud (1) on the inside with the TOP arrow pointing towards the Corner Stud as shown in Figure C. Use a Long Bolt (60) to attach the Brace. Attach the other three Side Diagonal Braces (22) to the other Corner Studs (1) in the same manner.

6.Attach the center hole of each Brace to the Long Bolt (60) in the center of the Side Studs (12) designated with an asterisk (*) in Figure C. This Bolt (60) was included in step 4, above.

7.Attach the bottoms of all four Side Diagonal Braces (22) to the Long Bolts (60) installed at the bottoms of the remaining Side Studs.

	Right	Left
to	Doorway	Doorway	to
	Stud (7)	Stud (6)
Corner			Corner
Stud (1)			Stud (1)
		Front Floor Plate (17)

View from above

8.Install the Left and Right Doorway Studs (6 & 7) to the outside of the frame so that they rest flat against the frame. Their orientation should be the same as shown above. Slide a Long Bolt (60) into each slot for later Front Brace (21) assembly. Make the bottom connections using a Long Bolt (60) for later assembly of the Front Diagonal Braces (24). Slide a Hold-Down Connector (44) under the base and over

SKU 93920 For technical questions, please call 1-800-444-3353. Page 10