Harbor Freight Tools 93920 manual Frame Assembly, Assembling the Outer Frame

FRAME ASSEMBLY

•Unless noted otherwise, all frame parts will be attached using the Short

Bolts (59) and Nuts (61) provided. Bolts should all be assembled with their heads facing the outside of the greenhouse. Tighten Nuts only about 1/4 turn past finger-tight; be careful not to overtighten.

•Lay out all parts by number prior to assembly.

•An assistant or an appropriate support (not included) will be useful to keep the partially assembled parts upright during assembly.Two assistants should be used to assemble the Crown pieces to the rest of the frame.

•Assemble on a clear, calm day. Wind may damage the Greenhouse and will make assembly difficult.

Cross Section

Assembling the Outer Frame

1.Use the bracket built into Side Floor Plate A (18a) to attach Side Floor Plate B (18b). Repeat for the second pair of Side Floor Plates. Lay all Floor Plates (16-18b) out on top of the base with the flanges facing the outside of the greenhouse as shown above. Make sure that the Front Floor Plate (17) is on the side that you want your door to be located.

2.There are four Corner Studs (1) to be attached to the Floor Plates (16-18b), the end with two holes should be at the bottom. Attach one Corner Stud (1) on the outside of each corner using two Bolts. As shown above: 1) slide a Hold Down Connector

SKU 93920 For technical questions, please call 1-800-444-3353. Page