3.Orient the assembled door frames for so that the Outer Door Frame (27a) is on the left, and the Inner Door Frame (27b) is on the right. This is the assembly used for the left door, the right door will be assembled later with the Outer and Inner Door Frames on the opposite sides (outer on right, inner on left). All illustrations show the left door assembly.
4.Attach the Top Door Frame (30) to the top of the Outer/Inner Door
| Frames (27a, 27b). Make sure that the rounded portion faces |
|
|
|
| the front and that the flange where the pane will sit faces down |
|
| 30 |
| towards the center of the door, see the diagram to the right. |
|
| |
| 27a |
|
| |
5. | Using two Short Bolts (59) and two Nuts (61), attach the Door |
|
| Pane |
|
|
| ||
| Slider (29) to the Top Door Frame (30) with the rollers on the top |
|
|
|
| of the door. |
|
|
|
6. | Insert a Door Bottom Slider (64) into each end of the Bottom Door |
| 27b | 32 |
| Frame (32). Make sure that the Sliders are assembled the correct |
|
| |
|
|
|
| |
| way, with the gap facing the back of the door – see diagram to |
|
|
|
| the right. Attach the Bottom Door Frame (32) to the Outer/Inner |
|
|
|
| Door Frames (27a, 27b) using two Screws (57) on each side – the | 57 |
| 64 |
| one on the top into the Bottom Door Frame (32) and the bottom |
| ||
|
|
|
|
one into the Door Bottom Slider (64).
7.Raise the assembled Door up and insert the first roller of its Door Slider (29) onto the Door Rail (28). Carefully align the first Bottom Door Slider (64) over the edge of the Front Floor Plate (17) – see illustration to the right. Carefully slide the door over and align the other top Roller and bottom Slider as you did the first ones.
8.Assemble and install the right door by following the preceding
steps, except place the Outer and Inner Door Frames (27a, 27b) on the opposite sides as explained in step 3.
9.Once both doors are installed, install a Short Bolt (59) and Nut (61) into the hole on the ends the Door Rail (28) to prevent the doors from sliding off the rails. Attach the Right and Left Rail End Caps (70,71) onto the ends of the Door Rails.
SKU 93920 | For technical questions, please call | Page 14 |
