(26)is unplugged from its electrical outlet prior to making any adjustments to the tool. (See Figure A.)
2.Chuck (11): Accepts up to 3/8” shank diameter Drill Bits (not included). To install a Drill Bit with the Cordless Drill pointed away from your body, hold the Chuck Sleeve firmly in place and turn the Chuck clockwise. Insert the shank of a Drill Bit all the way into the Chuck. While holding the Chuck Sleeve in place, turn the Chuck coun- terclockwise to lock the Drill Bit in place. (See Figure A.)
3.Trigger (19): The Trigger is operated manually simply by squeezing the Trigger to turn on the Cordless Drill and releasing pressure on the Trigger to turn off the Cord- less Drill. The drill will go faster the more the trigger is squeezed.
(See Figure A.)
4.Reversing Lever (23): The Reversing Lever Switch allows you to change the rotational direction of the Cordless Drill. To change the rotational direction, make sure the Cordless Drill is at a complete stop. For a clockwise rotation, move the Switch to the right. For a counterclockwise rotation, move the Switch to the left.
(See Figure A.)
5.Torque Selector Ring: The Torque Selector Ring allows you to select up to 16 dif- ferent driving torque settings, depending on the job required. To change the driving torque, make sure the Cordless Drill is at a complete stop. Then, simply turn the Torque Selector Ring to the desired setting. The drill setting is used to force the chuck not to slip and is used when drilling. (See Figure A.)
Charging instructions
1.NOTE: The Battery Pack (22) requires charging. The first charge requires a 11/2 hour charge time prior to using the Cordless Drill. (See Figure A.)
2.When the Battery Pack (22) requires recharging, a 11/2 hour charge allows the tool to operate at full power. Do not recharge the Battery Pack longer than 11/2 hours, as damage to the Battery Pack and/or Charger (26) may occur. Do not leave the charger unattended while charging. (See Figure A.)
3.Make sure the Trigger on the Cordless Drill is in its “OFF” position. Slide the Bat- tery Pack (22) off of the Handle of the Cordless Drill. Next, slide the Charger Plug onto the Charging Socket of the Battery Pack. Then, plug the Charger (26) into the nearest 120 volt, grounded, electrical outlet. (See Figure A.)
4.Verify that the charging indicator light comes on. If it does not come on, check the power cord connection. Charge the Battery Pack (22) until the charging indicator light turns off and the charged indicator light comes on. When the Battery Pack (22) is fully charged, the Charger (26) will automatically shut off. (See Figure A.)
SKU 94434 | For technical questions, please call | PAGE |
