Harbor Freight Tools 94634 operating instructions INSPECTION, MAINTENANCE, and Cleaning

INSPECTION, MAINTENANCE, AND CLEANING

1.WARNING! Make sure the Power Switch (14) of the Curb Machine is in its “OFF” position and the machine is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

2.Before each use, inspect the general condition of the Curb Machine. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

3.After each use, clean the Hopper, Chute, Slip Form, and exterior Body of the Curb Machine thoroughly with water. Do not introduce water into the Motor compart- ment of the machine.

4.To replace the V-Belt,loosen the four Bolts (48) at the base of the Motor (25). Move the Motor towards the Gear Box (24). Slip the V-Belt (20) off the two Pulleys (21, 23). Install a new V-Belt (size A500) onto the two Pulleys. Move the Motor back to its original position. Then, firmly retighten the four Bolts.

(See Assy. Diagram.)

SKU 94634 For technical questions, please call 1-800-444-3353 PAGE 19