
FIGURE E
A
D
B
THE POSITION FOR AN ANGLE (90°) CUT.
.Setting up the Quick Vise for cutting a 12” workpiece:
•Remove both fasteners from the Rear Vise Jaw (22).
•Position (B) over the outer threaded hole on the Base (1).
•Position Slot (A) over the small rectangular opening across the Base (1).
•Attach Screws (A and B). Align the lower edge of the Rear Vise Jaw (22) with the “0” index mark adjacent to the 16° degree setting. Tighten the screws. (See Figure F)
FIGURE F
A
D
B
TO ADJUST THE STOP BLOCK
For repeated cuts of
1.Loosen the Thumb Screw (38) that holds the Stop Block (41) to the Stock Stop Rod (40). (See Figure G)
2.Adjust the Stop Block (41) to the desired length position. Then
SKU 97009 | For technical questions, please call | Page 14 |