3.To operate, turn the Hand Wheel (5S) counterclockwise 1/2 turn and move the Front Vise Jaw (9) to the desired position. Then tighten the Front Vise Jaw against the workpiece by turning the Hand Wheel clockwise. (See Figure C.)

HAND WHEEL (5S)

FIGURE C

FRONT VISE JAW (9)

 

 

 

REAR VISE JAW (22)

 

 

 

HAND WHEEL (5S)

4.Setting up the Quick Vise for a straight (0°) cut:

Loosen the Screws (H) and (G) of Front Vise Jaw (F).

Turn the Hand Wheel (5S) counterclockwise by half a turn and slide back the Front Vise Jaw (9).

Loosen Screw (A and B) and note that Screw (A) should be in the slot which is parallel with the Rear Vise Jaw.

Rear Vise Jaw at the scale side should be aligned with the zero (0) on the rule. Tighten Screws (A and B). (See Figure D.)

BASE (1)

FIGURE D

22

 

 

 

 

C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A

 

 

 

 

 

 

 

 

D

G

9

H

B

ORIGINAL POSITION (FOR 0° CUTTING)

.Setting up the Quick Vise an angle:

Note: Make sure “C” slot is free of casting flush so the vise can be positioned in all angles.

Remove Screws (A and B) from base of the Rear Vise Jaw (22).

Position (D) over (B) and attach the Screw and Washer (19 and 22) and attach Screw

(B).

Attach Carriage Screw (17) onto Slot (C) through the curved slot in the Base (1).

Align edge of the Rear Vise Jaw with the indexing rule and tighten Screws at (B and C). (See Figure E.)

SKU 97009

For technical questions, please call 1-800-444-3353.

Page 13

Page 13
Image 13
Harbor Freight Tools 97099 Setting up the Quick Vise for a straight 0 cut, . Setting up the Quick Vise an angle