11.Never attempt to remove material stuck in the moving parts of the Bandsaw while it is plugged in and running. Turn off the Bandsaw if the workpiece is to be backed out of an uncompleted cut.
12.Once the cut is made, turn the Motor Toggle Switch (750S4) to its “OFF” position. Turn the Coolant Pump Toggle Switch (750S2) to its “OFF” position. Turn the Coolant Pump Fitting (91S) to its “CLOSED” position. The unplug the Power Cord (500) from its electrical outlet. (See Figure S.)
13.Wait until the Saw Blade (251) comes to a complete stop. Then remove the workpiece and scrap material from the Vertical Saw Table
(See Figure S.)
14.Turn the Cylinder (216) to its “ON” position. Slowly lower the Saw Head Assembly to its horizontal position. Then turn the Cylinder to its “OFF” position to lock the Saw Head Assembly in place. (See Figure S.)
BASIC BANDSAW OPERATION - HORIZONTAL POSITION
1.WARNING!
•Always wear
•When operating the machine, keep the Bandsaw Blade enclosure closed.
•Do not plug the Power Cord into an electrical outlet until all necessary adjustments (as previously discussed in this manual) have been made.
•Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade (251) tension or machine vibration. If this is found, turn off the Bandsaw and correct the problem before using.
•Always keep hands and fingers safely away from the cutting area.
2.Turn the Cylinder (216) to its “ON” position, and raise the Saw Head to its full vertical position. Then turn the Cylinder to its “OFF” position to lock the Saw Head in place. (See Figure T, next page.)
3.Secure the workpiece in the Vise (9, 22) assembly. When cutting a large workpiece, make sure its entire length is properly supported. If necessary, use a roller stand (not included) with a large workpiece. (See Figure T, next page.)
4.If cutting several workpieces at the same length, you may wish to adjust the Stop Block (41) to the desired position. (See Figure T, next page.)
.Check to make sure the Motor Toggle Switch (750S4) and Coolant Pump Toggle Switch (750S2) are both in their “OFF” positions. (See Figure T, next page.)
SKU 97009 | For technical questions, please call | Page 23 |
