Specifications
| Housing: Sheeted | |
| Steel | |
| Roller and Block | |
Construction Materials | Stop: Polyethylene | |
| Hardware: Carbon | |
| Steel | |
| Feet: Rubber | |
Sanding Disc | 6” | |
|
| |
Sanding Belt | 4” W X 36” L , 80 Grit | |
| 3/4 HP PEAK | |
Motor and Electrical | 120V | |
60Hz, | ||
Information | ||
Amps - With Load: | ||
| ||
| 3.5 AMP’S | |
Plug | ||
Belt Speed | 1150 FPB | |
Disc Speed | 1780 RPM |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent
WARNING serious injury from
accidental operation: Turn the Power Switch of the Belt/Disc Sander to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
Feet Placement
1.Carefully set the Belt/Disc Sander on its side.
Figure 1
Rubber Pads (28)
2.Press each Rubber Pad (28) over the lip of the Base at each corner. (See Figure 1)
SKU 97181 | For technical questions, please call | Page 9 |
