Test by pressing in the middle with a moderate amount of force.
b. Turn off the sander and un-plug the power cord.
c. Remove the pulley/V-Belt Side Cover (82).
d. Check the V-Belts for signs of wear, deterioration or cracking. If any signs are visible, replace with a new belt.
e. The Feed V-belt (99) is tensioned by loosening the Motor Bracket (100) screws and sliding the motor down- ward to tighten the V-Belt.
f.The Drive V-Belt (97) is tensioned by pressing the tensioner Roller
(255)against the V-belt, increasing pressure until the V-belt is of proper tension.
g.These V-Belts are subject to stretch- ing and loosening, so they must be checked on a regular basis and tensioned whenever necessary.
h.Replace the pulley/V-Belt Side Cover
SKU 98198 | For technical questions, please call 1-800-444-3353. | Page 14 |
