Note: For additional information regarding the parts listed in the following pages, refer to the 99599 Assembly Diagram on pages 12 and 13 of this manual.
1.Slide Head (12) into Housing Open- ing (15). While holding Head, place Locking Knob (16) into slot on Left side of Motor Housing (17).
2.Turn Locking Knob clockwise until tight and Head fastened securing to housing.
3.Twist Feed Screw (100) into Head. Continue twisting until Feed Screw Base (101) is fastened securely into housing.
4.Slide Cutting Blade (11) onto Feed Screw, making sure the edges of Cut- ting Blade face front of housing.
5.WARNING! Cutting Blade has sharp blades. Wear gloves and use care when installing Cutting Blade.
6.Slide selected Cutting Plate (6, 7, or 8) over Cutting Blade, using the slot along Plate edge as guide.
7.Screw Cap (1) into place on hous- ing until secure. CAUTION! Do not overtighten.
8.Slide Hopper Plate (13) onto top of Head until secure.
9.Set Grinder on flat and stable counter space that does not block vents along bottom of housing.
10.Cut foods into small pieces that can easily fit into Hopper.
Operation
(For 99598 Meat Grinder)
Read the entire Important Safeguards section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.Once food is ready, remove the Power Cord (19) from the Cord Com- partment (20) and plug Cord into outlet. The red Power light will turn on. Press On Key (35) to activate.
2.Feed food into Hopper Plate. Use Food Pusher (14) to press food down Plate and into Head.
3.WARNING! Do NOT use fingers to push food into Grinder. Only use Food Pusher.
4.Please note: While On Key is pressed, a beeping will sound and the green ON light will activate.
5.To stop the Grinder, press the Off Key (33).
6.In case of a food blockage, press Off key and then Reverse Key (31). The green reverse light will activate.
7.Please note: To change from reverse to forward direction, first press Off for at least three seconds before press- ing On again. This will help prevent damage to motor.
8.CAUTION! Machine should not be run for longer than 20 continuous minutes. The motor will deactivate automatically after 1 hour of continu- ous running.
SKU 99598/99599 For technical questions, please call | Page 8 |
