AVR80 manual 11/01/98 13:01 Side 9
Remote Control Functions
9
ENGLISH
n
oMemo: The memo button is used to enter stations to the tuner’s preset memory in either the manual or automatic modes. It is also used in the process of clearing the memory.
pDelay: This button controls the amount of sound delay to the rear (surround) channels. Press it to increase the delay in the steps shown in the main Information Display or
qMenu Controls: These buttons control the action of the cursor or the selection of menu items when the receiver is being configured using the setup menus.
rSelect: This button chooses a menu and enters settings to the receiver’s memory during system configuration.
sScreen Display: Press this button to activate the on screen menu system.
tPanel Display: Press this button to turn off all displays and indicators in the Information Display except for a small DISP indication in the lower right corner of the display Û Press the button again to turn the display back on. Note that the display will briefly illuminate when a command is sent to the unit from the front panel or remote, even though the display is turned off.
uTest Noise: Press this button to begin calibration of the output level for each channel. A test signal will immediately be heard from the left front speaker and the TEST indicator ª will flash.
vSpeaker Select: When setting the system output levels, this button selects the speaker position being adjusted. Press it once to advance to the next speaker after each position is adjusted.
wLevel Adjust: When setting the system output levels, press these buttons in increase or decrease the output level.
xSending LED: This indicator should flash any time a button is pressed to confirm that a command is being sent to the receiver or another unit. If the light is dim or does not illuminate when a button is pressed the batteries in the remote should be replaced.
yLearn LED: This indicator will illuminate when a button on the remote is being programmed with signals from another remote during the “learning” mode. The light will go out when the signal is received and memorized.
z RDS PTY: Press this button to view the Programme Type information for stations transmitting RDS data. This button is also used for PTY Auto Search functions.
`RDS AF: This button initiates a search of alternate frequencies to find an eventually stronger signal for the station type currently selected.
