AVR80 manual 11/01/98 13:01 Side 27
The following functions of the AVR80 may be controlled through the Menu Control System:
INPUT SELECTION: After reaching the INPUT SELECTORmenu (Figure #13), use the arrow keys on the remote qto select the desired input. Remember that when a split listening session is desired, select the VIDEO source first, followed by the AUDIO source. To use the Tape Monitor, press the down arrow button Û qto move the
RECORDOUTSELECTION: After reaching the REC OUT SELECTOR menu (Figure #14) use the navigational arrow keys to select the record source for either TAPE 1or VCR 1. Note that if the current main input SOURCEis chosen, two more lines will appear on the screen to remind you which audio and video sources are selected (Figure #15). The RECORDOUTSELECTION effects the same as the ‘Copy’ Pushbuttons ð ñon the front panel.
On Screen Display
27
SURROUND MODE: After reaching the SURROUND MODEmenu (Figure #16), use the navigational arrows qto select the desired mode. When a mode is selected that uses the surround channels, you may change the rear channel DELAY TIMEat this menu.
TEST TONE: At this menu you may adjust the speaker output levels. For information on this procedure, refer to the System Configuration section of this Manual, page 18.
SET UP MENU: For information on using the Set Up menus, refer to the System Configuration section of this Manual.
R E C O U T S E L E C T O R
>T A P E * S O U R C E *
V C R 1 * S O U R C E *
A U D I O * T U N E R *
V I D | E O | * L D * |
R E T U R N | T O M A I N M E N U |
Figure 15
S U R R O U N D M O D E
> M O D E | : T H X C I N E M A |
D E L A Y T I M E : 2 0 m s | |
R E T U R N | T O M A I N M E N U |
Figure 16
ENGLISH