Harman-Kardon AVR 154 owner manual Step Nine - Turn On the AVR, Installation, Power Switches

INSTALLATION

the Remote Control Function List, Table A9 in the Appendix, for each button’s functions with the various product types.

You may program Macros, which are preprogrammed code sequences that execute many code commands with a single button press. You may also program “punch-through” codes, which allow the remote to operate the volume, channel or transport controls of another device without having to switch the remote’s device mode. See pages 44 through

45 for instructions on these advanced programming functions.

NOTE: The AVR 154 remote is preprogrammed to operate the transport controls of Harman Kardon DVD players when the AVR or the Video 2 (cable/satellite) or Video 3 (TV) source is selected. You may change this punch-through programming at any time.

Step Nine – Turn On the AVR 154

Two steps are required the first time you turn on the AVR 154.

1.Gently press the Master Power Switch until the word OFF is no longer visible. The Power Indicator above the two power switches should light up in amber, indicating that the AVR is in Standby mode and is ready to be turned on. See Figure 38. Normally, you may leave the Master Power Switch in the ON position, even when the receiver is not being used.

Figure 38 – Power Switches

2.There are several ways in which the AVR 154 may be turned on from Standby mode.

a)Press the Standby/On Switch on the front panel. See Figure 38.

b)Press the Source Select Button on the front panel. See Figure 39.

Figure 39 – Source Select Button

c)Using the remote, press any one of these buttons: AVR, DVD, CD, TAPE, AUX, HDMI 1, HDMI 2, HDMI 3, VID1, VID2, VID3, AM/FM or 6CH. See page 13.

NOTE: Any time you press one of the Input Selectors, the remote will switch to the corresponding device mode and will only operate that device. To control the receiver, press the AVR Button to return the remote to AVR mode.

27