Harman-Kardon AVR 155 Front Panel Controls, Headphone Jack $ Speaker/Channel Input Indicator

Front Panel Controls

ENGLISH

1 Volume Control	! Tuner Band Selector	Ô Video 3 input jacks
2 System Power Control	@ OK Button	 Digital Input Selector
3 Power Indicator	# Preset Stations Selector	Ò Main Information Display
4 Headphone Jack	$ Speaker/Channel Input Indicator	Ú Remote Sensor Window
5 Surround Mode Group Selector	% Input Source Selector
6 Speaker Select Button	^ RDS Select Button
7 Selector Buttons	& Delay
8 Tone Mode	* Digital Optical 3 Input
9 Surround Mode Selector	( Channel Select Button
) Tuning Up/Down	Ó Digital Coax 3 Input

1Volume Control: Turn this knob clockwise to increase the volume, counterclockwise to decrease the volume. If the AVR is muted, adjust- ing volume control will automatically release the unit from the silenced condition.

2System Power Control: When the Main Power Switch ￿ on the rear panel is “ON,” press this button to turn on the AVR; press it again to turn the unit off (to Standby). Note that the Power Indicator 3 will turn white when the unit is on.

3Power Indicator: This LED will be illuminated in amber when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn white.

4Headphone Jack: This jack may be used to listen to the AVR’s output through a pair of head- phones. Be certain that the headphones have a standard 6.3 mm stereo phone plug. Note that the speakers will automatically be turned off when the headphones are connected.

When configuring your system using EzSet/EQ, the calibration microphone should be plugged into this jack 4 using the supplied adaptor that converts the small mini-plug at the end of the microphone’s cord to a 1/4" plug.

5Surround Mode Group Selector: Press this button to select the top-level group of surround modes. Each press of the button will select a major mode grouping in the following order:

Dolby Modes ‹ DTS Digital Modes ‹ DSP Modes

‹Stereo Modes ‹ Logic 7 Modes

Once the button is pressed so that the name of the desired surround mode group appears in the Main Information Display Ò, press the Surround Mode Selector 9 to cycle through the individual modes available. For example, press this button to select Dolby modes, and then press the Surround Mode Selector 9 to choose from the various mode options.

6Speaker Select Button: Press this button to begin the process of selecting the speaker positions that are used in your listening room. (See page 17 for more information on setup and configuration.)

FRONT PANEL CONTROLS 5