Advanced Features
The AVR 510 is equipped with a number of advanced features that add extra flexibility to the unit’s operation. While it is not necessary to use these features to operate the unit, they provide additional options that you may wish to use.
Display Brightness
The AVR 510’s Main Information Display
Ûis set at a default brightness level that is sufficient for viewing in a normally lit room. However, in some
To change the display brightness setting for a specific listening session, you will need to make an adjustment in the ADVANCED SELECT menu. To start the adjustment, press the OSD button v to bring the MASTER MENU to the screen. Press the ¤ button n six times, until the
* A D V A N C E D | S E L E C T | * | |||||
|
| ||||||
V F D | : | F U L L | H A L F O F F | ||||
|
|
|
|
|
|
|
|
V O L U M E D E F A U L T : | O F F | O N | |||||
D E F A U L T V O L | S E T : |
| |||||
S E M I O S D : O F F | O N |
|
| ||||
S E M I O S D T I M E O U T : | 3 5 |
F U L L O S D T I M E O U T : 2 0 5
R E T U R N T O M E N U
Figure 9
To change the brightness setting, at the ADVANCED SELECT menu, make cer- tain that the
VFD line, and press the › button 31 until the desired brightness level is highlighted in the video display. When FULL is highlighted, the display is at its normal brightness. When HALF is highlighted, the display is at half the normal brightness level. When OFF is high- lighted, all of the indicators in the Main Information Display Û will go dark. Note, however, that the green LEDs for the Input Indicators and the Surround Mode Indicators ˜, as well as for the Power Indicator 3, will always remain lit to remind you that the unit is turned on.
The display brightness may also be changed by pressing and holding the Set button Ô on the front for three seconds until the message in the Main Information Display Y reads VFD
FULL. Within five seconds, press the front panel Selector buttons 5 until the desired brightness display level is shown. At that point, press the Set button Ô again to enter the setting.
Once the desired brightness level is selected, it will remain in effect until it is changed again or until the unit is turned off.
If you wish to make other adjustments, press the ⁄/¤ buttons n until the
Turn-On Volume Level
As is the case with most audio/video receivers, when the AVR 510 is turned on, it will always return to the volume setting in effect when the unit was turned off. However, you may prefer to always have the AVR 510 turn on at a specific setting, regardless of what was last in use when the unit was turned off. To change the default condition so that the same volume level is always used at
At the ADVANCED SELECT menu make certain that the
the › button 31 so that the word ON is highlighted in the video display. Next, press the
¤button n once so that the
NOTE: Since the setting for the
Ó34 î. When the desired volume level to be used at
Unlike some of the other adjustments in this menu, the
If you wish to make other adjustments, press the ⁄/¤ buttons n until the
Semi-OSD Settings
The
To turn off the
¤cursor is next to the ADVANCED line. Press the Set button p to enter the ADVANCED SELECT menu.
At the ADVANCED SELECT menu, make certain that the
Note that this setting is temporary and will remain active only until it is changed or until