Harman-Kardon BDP 1 owner manual Step Six Network Connection, Step Seven Plug In AC Power

INSTALLATION

Figure 6 – Remote IR Input and Output

Step Six – Network Connection

Connect the Network Jack to a router or Ethernet-compatible controller. See Figure 7. The network connection is used for BD-Live discs to access the Internet for updates to the disc content and special features. A USB drive with at least 1GB capacity is required for BD-Live functionality. Select the “Storage” option in the USB Function Select menu.

Figure 7 – Network Jack

Step Seven – Plug In AC Power

To avoid possible damage from a transient power surge at plug-in, turn off the Master Power Switch. Plug the female end of the AC Power cord into the receptacle (see Figure 8), and the male end into an unswitched AC outlet.

Figure 8 – Master Power Switch and AC Power Input

Step Eight – Insert Batteries in Remote

The BDP 1 remote control uses two AA batteries (included).

To remove the battery cover located on the back of the remote, lift the tab until the latch releases, and lift the battery cover up. To replace the cover, insert the two small tabs at the top of the cover into the recesses at the top of the battery compartment, and lower the cover, pressing the latch at the bottom until it snaps shut.

Insert the batteries as shown in Figure 9, observing the correct polarity.

Figure 9 – Remote Battery Compartment

Point the remote toward the front panel of the BDP 1. The IR receiver is located immediately to the right of the Message Display. Make sure no objects are blocking the remote’s path. Bright lights, fluorescent lights and plasma video displays may interfere with the remote’s functioning. The remote has a range of about 20 feet (6 meters), depending on the lighting conditions. It may be used at an angle of up to 30 degrees to either side of the BDP 1.

If the remote seems to operate intermittently, make sure the batteries have been inserted correctly, or replace both batteries with fresh ones.

16