Batteries
Insert the two AA batteries supplied with the CDR 26’s remote by turning the remote over so that the bottom of the remote is facing towards you. Gently lift the plastic tab on the battery cover up and away from you, and lift the lid off. Insert the batteries in the remote, being careful to follow the + and – polarity indications in the bottom of the compartment. Replace the cover by first seating the two small tabs into the mating holes at the top of the remote, and then gently push the cover down until the latch snaps into place with an audible click.
INSTALLATION AND CONNECTIONS
IR Remote Connections
If the CDR 26 is installed behind a cabinet or other obstruction that may block the path between the front- panel Remote Sensor ˆ and the location where you will use the remote, an optional external IR sensor may be used. Connect the sensor to the Remote IR In Jack ¶ on the rear panel. This jack may also be connected to the IR Output jack of another compatible Harman Kardon component or a compatible IR system remote product.
You may also use the IR sensor in the CDR 26 to send commands to other compatible remote products. Connect the Remote IR Out Jack • to the input of the other product or system.
Power Connections
Connect the AC Power Cord ª to an AC power source. The CDR 26 uses sensitive,
If the
If the CDR 26 is connected to a switched outlet, remember to turn on the outlet or product controlling it in order for the CDR 26 to operate.
NOTE: When replacing batteries, it is always a good idea to replace both at the same time. When the remote will not be used for an extended period of time, it is also a good idea to remove the batteries to avoid the possibility of damage due to corrosion. Batteries contain chemical substances and we recommend that you dispose of them properly and in compliance with any local regulations.
