REAR-PANEL CONNECTIONS
| AC 110~240V, 50~60Hz 20W |
| MODEL NO. CDR 26 |
| HARMAN KARDON |
| NORTHRIDGE |
| CALIFORNIA. USA |
| OPTICAL |
IN | OUT |
¡ | £ | ∞ | ¶ | ª |
™ | ¢ | § | • |
|
¡ Analog Output |
| ¢ | ¶ Remote IR Input | |
™ Analog Input |
| ∞ | • Remote IR Output | |
£ |
| § | ª AC Power Cord |
¡Analog Output: These jacks carry the analog audio output signal from the deck currently playing. Connect them to the Tape Play/In input jacks on a receiver, preamp or processor.
™Analog Input: These jacks accept the analog sig- nals that are used for CD recordings. Connect them to the Tape Rec/Play outputs on a receiver, preamp or processor.
£
¢
IMPORTANT NOTE: The coaxial digital input should only be connected to digital input or output jacks. Even though it uses the same
∞
§
¶Remote IR Input: Connect the output of a remote infrared sensor or the remote control output of another compatible Harman Kardon product to this jack. This will enable the remote control to operate even when the
•Remote IR Output: Connect this jack to the IR input jack of another compatible Harman Kardon
ªAC Power Cord: Connect this plug to an AC out- let. If the outlet is