Harman-Kardon II manual For Wall-Mounting

For Wall-Mounting

Note: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.

1.Remove the Modulus II from its box. Remove rubber cover from base and pull out Allen wrench. Use Allen wrench to remove mounting plate screw and remove mounting plate from base.

FIGURE 7

Adjustment

Screw

Allen Wrench

Housed

in Base

Rubber	Speaker
Cover	Base
Mounting Plate Screw
Mounting Plate

2.Secure the mounting plate to a wall stud using (4) #8-32 wood screws with a minimum 1-1/4" length. If fastened to wallboard with a minimum 1/2" depth, use #8 screws with plastic inserts or anchors. Do not mount directly to wallboard without plastic inserts or anchors designed for #8 screws. One of the mounting plates in the Modulus II system has a built-in bubble level. This mounting plate should be used as a template for mounting the mounting plates that do not include a bubble level.

2a. In cases where you would like to run the speaker wires through the wall, the mounting plate has a center hole for wire access.

FIGURE 8 WALL Bubble Level

Hole in the Wall

#8-32 Wood

Screws (Not

Included)

Speaker Wires

3.Run speaker wires through base as shown below. Attach base to mounting plate by slipping the returns on underside of base into slots on the top of the mounting plate and hinging the base downward. Secure base by inserting and tightening mounting plate screw.Tighten adjustment screw, fixing the speaker into position.

FIGURE 9

Returns on

Underside of Base

Rubber Cover Adjustment Screw

Allen Wrench

Speaker Wires

Viewed From Below	Note: Base Has Returns
	That Grab Mounting Plate

4.Insert the Allen wrench back into holder in base and attach rubber cover.

4 MODULUS II HOME THEATER SYSTEM