Harman MFXI STEREO INPUT CHANNELS MFXi shown, INPUTS STEREO 1/2, Gain, Mf Eq, Aux Sends, Lf Eq

L

1[MONO]

R

STEREO 1

		GAIN
2
	-10	20dB
	3	- 0+ 3	HF
	6		6
	9		9
	12		12
	15	15
	3	- 0+ 3	MF
3	6		6
	9		9
	12		12
	15	15
	3	- 0+ 3	LF
	6		6
	9		9
	12		12
	15	15

AUX1

4
0	10

AUX2

0 10

FX

5
	0	10
	0	BAL
6
	L	R
7	STE1
	MUTE
9	PFL
	MIX
	SUB
12		PK
		SP
10		10
		5
11
		0

8 -5 -10

-20

-30

STEREO INPUT CHANNELS (MFXi shown)

1 INPUTS STEREO 1/2

These inputs accept 3-pole 6.35mm (1/4”) jacks. Use these inputs for sources such as keyboards, drum machines, synths, tape machines or processing units. The inputs are BALANCED for low noise and top quality from professional equipment, but you can use UNBALANCED sources by wiring up the jacks as shown in the ‘Wiring Up’ section earlier in this manual, although you should then keep cable lengths as short as possible. Mono sources may be used by plugging into the left jack only.

2 GAIN

The GAIN control sets the level of the channel signal.

3EQUALISER HF EQ

Turn to the right to boost high (treble) frequencies, adding crispness to percussion from drum machines, synths and electronic instruments. Turn to the left to cut these frequencies, reducing hiss or excessive brilliance. Set the knob in the centre-detented position when not required. The control has a shelving response giving 15dB of boost or cut at 12kHz.

MF EQ

Turn to the right to boost mid frequencies by up to 15dB, turn to the left to cut these frequencies by up to 15dB. The centre frquency of the MF EQ is 720Hz.

LF EQ

Turn to the right to boost low (bass) frequencies, adding extra punch to synths, guitars and drums. Turn to the left to reduce hum, boominess or improve a mushy sound. Set the knob to the centre-detented position when not required. The control has a shelving response giving 15dB of boost or cut at 80Hz.

4AUX SENDS

These are used to set up separate mixes for FOLDBACK, EFFECTS or recording, and the combination of each Aux Send is mixed to the respective Aux Output at the rear of the mixer. For Effects it is useful for the signal to fade up and down with the fader (this is called POST-FADE), but for Foldback or Monitor feeds it is important for the send to be independent of the fader (this is called PRE-FADE).

AUX SEND 1 is fixed pre-fade,AUX 2 is globally switchable between pre and post-fade (see master section on page 28). On the MPMi, Aux 3 is fixed post-fader. The send pots are fed with a mono sum of the L & R signals.

AUX 3 SEND (MPMi) AUX1

Aux 3 is fixed post-fader.	4
	0	10

AUX2

010

STE1 AUX3

0 10

Soundcraft MFXi MPMi User Guide Issue 1210 25