Harman MPMI The following controls are found on the MFXi Console only FX, 23 PRE/POST SWITCH

23 PRE/POST SWITCH

This switch globally selects the AUX 2 feeds on all the input modules to be either pre-fade or post-fade.

24 AUX OUTPUTS 1 & 2 (and 3 on MPMi)

These outputs are on 3-pole 6.35mm (1/4”) jacks and are balanced.

The following controls are found on the MFXi Console only

FX

For detailed instructions on using the FX Processor see the section which starts on the next page.

25 FX MASTER

This control regulates the signal level being fed from the FX bus to the FX processor and to the FX BUS OUTPUT socket.

26 FX AFL

When the latching AFL switch is pressed, the post-FX-Master (25), pre-FX signal is fed to the headphones, control room output and meters, where it replaces the MIX. The SOLO LED on the Master section illuminates to warn that an AFL is active.

27 FX BUS OUTPUT

This output carries the signal from the FX bus. It could be used as a third Aux Output if desired if the FX Processor is not needed at the time. The FX sends on the input channels to the FX bus are always post-fade. (on the MPMi, the FX Send output becomes Aux 3 output)

28 MUTE FX (FOOTSWITCH)

Using a single pole, momentary footswitch inserted into the MUTE FX input the effects processor can be muted/un-muted.

STEREO RETURN - MFXi Console only

29 STEREO RETURN INPUTS

This pair of inputs accept 3-pole ‘A’ gauge (TRS) jacks. Use these inputs for sources such as keyboards, drum machines, synths or CDs. The inputs are BALANCED. Mono sources may be used by plugging into the left jack only.

30 STEREO RETURN LEVEL

This control sets the level of signal routed to the main mix busses.

32 Soundcraft MFXi MPMi User Guide Issue 1210