19
ASSEMBLY
The remote control handset is powered by a 9-volt battery.
There is a low battery indicator on the handset display panel.
To replace the battery, remove the access cover from the rear of
the handset and unsnap the old battery. Replace with a high
quality long-life alkaline battery and reinstall the cover.
BATTERY INSTALLATION OR REPLACEMENT
The batteries used to power the burner control systems on the FireLuxe should last a full season or more
with normal use. Battery life for the main burner control system will be reduced if you are manually modu-
lating the flame up and down on a frequent basis.
There are three battery locations.
The electronic ignition module for the cooking burner is located behind an access panel located on the right
rear of the stove (when looking from the stove front). A single fastener secures the panel. Simply remove
fastener and the panel to access the single 9-volt battery. Unsnap the old battery from the module and re-
place with a fresh one. Use a high quality long-life alkaline battery. Replace the access panel and fastener.
Refer to the illustrations below.
ACCESS COVER
FASTENER
9V BATTERY
Next, reinstall the top. This is a gravity fit. Carefully align the inner edge of the top with the outer edges of
the sides and front. Lower the top down into place. Check to see if it is level and push down as needed to
get the proper alignment relative to the aesthetic details on the front and sides.
Finally, install the top cooking grate. This simply sits over the burner. A raised border on the stove top de-
fines the cooking grate position.