Harman Stove Company manual P61-2 Manual Start UP, Operation Starting First Fire

P61-2 MANUAL START UP

Fig. 17

Fig. 18

Fig. 19

1"

Fig. 20

Operation

Starting First Fire

Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel.

Fill the hopper with pellets.

Fill the burn pot with pellets to a level just short of overflowing, fig. 17.

Adjust feed rate. If this is your first fire or you are trying different pellets, set the feed adjuster to "3", fig. 18. This is a conservative number and will prob- ably need to be increased. After you know a feed rate setting that works well, use that setting. Re- member, too high a feed rate will waste fuel.

Turn Mode selector to "OFF" and then to "Stove Temp". This will turn the combustion blower to high. When starting a fire always turn the mode selector to "OFF" before selecting the desired mode. This resets the control for start- up.

Turn Temp Dial to 7. This will allow the stove to burn at maximum for feed rate adjusting pur- poses.

Apply starting gel to pellets in burn pot and light the gel. Close the door after lighting. At this point the distribution and combustion lights will be on and the feed motor light will be off. As the tem- perature of the fire increases, the feed motor light will come on and pellets will feed into the burn pot. As the stove temperature increases the dis- tribution blower speed will increase.

After 30 to 45 minutes it may be necessary to read- just the feed rate. The feed rate should be ad- justed so there is about one inch of ash in front of the fire, fig. 20. This is a maximum burn position and usually does not achieve this position under normal burn rates.

"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR SIMILAR LIQUIDS TO START OR "FRESHEN UP " A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IN USE".

12