OPTIONS
Room Sensor Installation
Hopper Extension
Fig. 44
The room sensor is a small temperature sensor on the end of a 60" gray wire. This sensor is installed much like a standard wall thermostat. Because it is so small, it can be hidden along the trim of a doorway or even up the leg of a coffee table. There is a remote room sensor port on the rear of the unit for easy exter- nal connection. Use standard
NOTE: Distances of more than 25 feet from the unit or in another room are not recommended. The room sensor is essential for the Accentra's excellent efficiency.
It is recommended that the room sensor be installed, even if only installed on the rear of the unit as a return air sensor. There is an intake screen on the bottom of the rear sheetmetal enclosure. This is an ideal place to tyrap the sensor head to sense return air tem- perature.
Side Heat Shields
Side heat shields are available to reduce the clearance to combustible materials. See Fig. 45.
The hopper extension allows you to put more pellet fuel in the hopper and extends burn time on one load of corn. The hopper extension adds 65 pounds to the existing 80 pound hopper capacity, allowing you to load 145 pounds of corn at one time. See Fig. 46.
Fig. 46
Optional Pellet Burnpot Grate
The pellet burnpot grate is required to burn pellet fuel.
The corn burnpot and pellet burnpot grates were designed to be interchangeable, and are easily installed and removed without the use of tools.
Each PC 45 comes with (2) corn burnpot grates to aid in continual burning of corn in the event that the corn burnpot needs to be cleaned. Please note they are both corn burnpot grates, not one corn grate and one pellet grate.
Fig. 45
Fig. 47: Optional Pellet Burnpot Grate
Optional Hopper Screen (Corn Strainer)
The hopper screen/corn strainer was designed to sift the corn before it is fed into the burn pot. This sifting will catch unwanted materials from being burned.
