MANUAL START UP
Fig. 26
Corn Burnpot
Fig. 27
Optional Pellet Burnpot
Fig. 28
Warning
"NEVER USE GASOLINE,
16 PC 45 Corn/Pellet Stove
Starting the Fire
Igniter Switch to"MANUAL" (down position)
Make sure the unit is plugged into a 120 VAC, 60 HZ electrical source. The power light should be the only light lit. Anytime there is interruption in power at the receptacle, the combustion blower will run for 1 minute after the power is regained.
Burning Corn
1.Turn the Feed Adjusterto desired feed rate,approximately #2.
2.Turn the Mode Selector to "OFF" and then to the desired mode. This will reset the control and start the combustion motor.
3.Turn the Temperature Dial to the desired setting.
4.Clean the burnpot and housing, if necessary.
5.Fill the burnpot with corn up to the auger shaft. Then place pellets on top of the corn as high as the shelf area. See corn burnpot shown on left.
6.Add starting gel on top of the pellets, stir gel into the pellets and corn for faster lighting.
7.Light the starting gel with a match and close the door. Operation will begin when the fire reaches the proper temperature.
8.Fill the hopper with corn and remove the ashes as required.
Burning Pellets
Optional pellet burnpot required to burn pellet fuel.
1.Turn the Feed Adjuster to the desired feed rate, approximately #4.
2.Turn the Mode Selector to "OFF" and then to the desired mode. This will reset the control and start the combustion motor.
3.Turn the Temperature Dial to the desired setting.
4.Clean the burnpot and housing, if necessary.
5.Fill the burnpot with pellets so that the auger tube opening is covered and slopes away from the auger tube opening. See pellet burnpot shown on left.
6.Add the starting gel on top of the pellets. Stir the gel into the pellets for fast lighting.
7.Light the starting gel with a match and close the door. Operation will begin when the fire reaches the proper temperature.
8.Fill the hopper with pellets and remove the ashes as required.
Shut-Down Procedure
To kill the fire or stop burning the stove, turn the Mode Selector to "OFF". This will cause the fire to diminish and burn out. When the fire burns out and the stove cools down every- thing will stop. NOTE: The combustion blower motor will run for 5 hours after the stove is completely cool. This in- sures that all fuel in the burnpot and ashes located in the ash pan are completely cold before shut down of the combustion motor.
If you pull the plug to shut down the stove, all motors will stop. This may cause incomplete combustion and smoke in the firebox. If the load door is opened the smoke may escape.
The best way to shut down the stove is simply let it run out of fuel, then the stove will shut down automatically.
