27PF100
Lighting A Fire Manually
Lighting the fire manually will not be necessary unless
the igniter in the burnpot fails.
Follow steps 1 through 5 of the instructi ons f or
automatic lighting.
6. Fl ip the Ignit er Switch Down into t he
"MANUAL-LIGHT" position. See Fig. 55.
7. Open inner and outer ash doors as shown
in figs. 63, 64, 65, on page 30.
8. Fill burnp ot wi th pe llet s as s hown .
See Fig. 57. Only fill level with the fr ont
edge. ( ------- DO NOT OVERFILL ------- )
9. Have matche s or othe r ig nition source
ready.
10. Apply starting gel as shown in Fig. 58.
NOTE: Stirring the starting gel into the pellets usually
allows the fire to become established quicker.
CAUTION: A vapor flash could occur if too much
time is allowed to pass before lighting the starting gel.
CAUTION: Care must be taken not to get starting gel
on your hands or clothing. Serious burns could occur during
the lighting process.
CAUTION: Never try to apply more starting gel to an
already burning fire, or a fire with smoldering pellets.
"NEVER USE GASOLINE, GASOLINE-TYPE
LANT ERN FUEL , KEROS ENE, CH ARCOA L
LIGHTER FLUID, OR SIMILAR LIQUIDS TO
START OR "FRESHEN UP " A FIRE IN THIS FUR-
NACE. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE FURNACE WHILE IN USE".
Fig. 55
Fig. 56
Fig. 57
Fig. 58
Operation