Scrape floor of burn pot with scraper to remove any carbon
Fig. 11
When filling hopper be sure to remove any pellets from ledge and around hinges before closing lid.
Starting a fire after proper Feed Rate is known.
Clean burn pot with scraper (supplied).
Fill the hopper with pellets.
Fill the burn pot with pellets to a level just short of overflowing.
Adjust feed rate to proper setting.
After you know what feed rate works well, then use that setting. (For example a setting of "5" produces 1" or more of ash on the burn pot with the brand of pellets you are using.) Remember, too high a feed rate will waste fuel.
Turn Mode selector to "OFF" and then to the desired mode.
Turn Temp Dial to the desired temperature. In Room Temp Mode this would be the outer scale marked in degrees. In Stove Temp Mode this would be the inner scale marked from 1 to 7.
Apply starting gel to pellets in burn pot as shown in fig. 10 and light the gel. Close the door after lighting.
At this point the distribution and combustion lights
will be on and the feed motor light will be off. As the temperature of the fire increases, the feed motor light will come on and pellets will feed into the burn pot. As the stove temperature increases the distribution blower speed will increase.
11
Fig. 12
