Exception F200 Wood Insert
Maintenance
Like all fine equipment, your Exception requires some routine maintenance and inspection. Follow the guidelines in this section to guarantee safe, efficient operation.
The Insert
Surface
The insert’s exterior surface should be dusted periodically with a soft cloth. For more thorough clean- ing, wait until the insert is cool before using a damp cloth to clean any blemishes.
The Door
The gold plated front door should never be buffed or polished. Abrasive cleaners and metal polishes will remove the plating and therefore should never be used. If the door needs to be cleaned, wait until the insert is com- pletely cool, then use a sponge, soap and water to gently remove dirt and stains. Before relighting the insert, re- move all soap residue and wipe dry.
Controls
To avoid a rust buildup on the inner surfaces of the controls, work the controls back and forth several times, during the summer, or any prolonged period when you are not using your insert.
The Fire Chamber
The inside of the fire chamber should be exam- ined for damage to the refractory lining material, After- burner hood and Afterburner glass. If any of these parts have been damaged, replace them with Harman Stove Company replacement parts.
Glass - Replacement
If the insert’s glass is cracked or broken, you must replace it before operating your insert. Remove pieces carefully. Replace glass only with Harman Insert Com- pany replacement glass panels; do not use substitutes.
To replace the glass panel(s), you will need to remove the door. To do this, open the door, lift it straight up and place it on a soft surface.
Carefully remove damaged glass, gasket material, and hold down clips (set aside).
Referring to the diagram, note how the various com- ponents of the door system fit together. Lay the load
door face down on the soft surface, and install the self adhesive 1/4"” gasket material around the front face of
the glass. Note: This glass has a special IR coating on one side. This coating must be to the outside of the in- sert. The coated side has a label on it. Do not remove the label before installing the glass. Remove label before burning the unit.
Set the glass pane and gasket gently onto the door. Install the hold down clips and tighten with bolts as shown.
Reinstall door on insert.
Glass Gasket
Glass
Hold Down Clips and Bolts
Glass - Cleaning
Door | Sometime it will be nec- |
| |
| essary to clean accumulated ash |
| from the glass surface; allowing |
| this ash to remain on the glass |
| for long periods can result in |
| “etching” due to the acidity of the |
| ash. The creosote which accu- |
| mulates on the glass should burn |
| off during your hot fires. |
| Never clean the glass |
| while it is hot, and do not use |
| abrasive substances. Wash the |
| surface with cool water, and |
| rinse thoroughly. You may wish |
| to use a nonabrasive cleaner spe- |
| cifically designed for use on in- |
| sert glass. In any case, dry thor- |
| oughly before relighting your in- |
| sert. |
8