Harman Stove Company The Harman Accentra Pellet Insert Installation11, Beginning Installation

Installation11

Beginning Installation

IMPORTANT: The mounting frame/surround
assembly and flue piping is the most critical part of
the installation andmust be done correctly and installed	Notch
securely.
1. Choose the chimney configuration that is best suited
for the installation. See venting section.
• Note: If 100% outside air is desired or required, the
outside air option will need to be installed on the stoves
body. (See instructions included with outside air kit
(part #1-00-674080.) See Page 20.
2. Make sure the unit will fit into the fireplace opening.
See Fig # 17. When installing in smaller fireplaces,
test fit the mounting frame into the firebox. Note: The
unit overhangs to the rear.

3" Outside Air starter collar

3.Install the 3 piece cast surround set to the sides and top of the mounting frame with the bolts and nuts supplied. The left and right side should be done before the center section is installed. Make sure the bolts are loose. Do not remove the side panel hinges. The left and right side wings should be standing up aligned with the side of the mounting frame and slid inward towards the center. Note:The wings mount on the rear side below the notch and on the front side above the notch. See Fig. 16 & 18. Slide the cast ash lip onto the frame and check to make sure it can go against the roped frame rails and fits into the pockets on the left and right cast sides. See Fig. 19.

Install the center section.

4.If the wing extensions are required they should be installed next.

Cast in front of the frame. Use (1)1/4-20 x 3/8 flange bolt from the rear.

Fig. 16 Ash lip slide rails

Fig. 17

Approximately 2" overhang

NOTE: The stove body extends through the mounting frame in the rear approximately 2".

Cast behind the mounting frame flange. Use (2) 1 / 4 - 2 0 x 5 / 8 flange bolts and nuts with bolts fromthe front.

Fig. 18

Slide the ash lip
casting into the
frame,	making
certain the ash lip
is sitting on the
slide	rails		on
either side. With
the ash		lip	in
place, adjust the
surround sides so
there is an even
gap where the ash
lip extends into				the
surround		side		and
tighten.				Fig. 19