Harman Stove Company The Harman Accentra Pellet Insert Installation16, Connecting the Room Sensor

Installation16

Connecting the Room Sensor

Connecting the room sensor to the blue twisted wires from the control board:

• (2) 3/16 inch male terminals are provided for the ends

of the room sensor wires.

• They will mate with the female terminals on the blue

twisted wires.

•These connections are “not polarity specific.”

Fig. 34

18. Install the front door. Check the latch and gasketing.

19.Inspect the silicone sponge gasket on the top edge

of the hopper.

• If it is okay, put the cast top/hopper lid assembly (see

Fig. 35) into place over the hopper.

• Make sure the hopper lid is open to install unit, then close it to keep from getting pinched in case the lid falls

unexpectedly.

• Insert the (4) 1/4-20 x 1/2 flange head bolts into the mounting hole but do not tighten them.See page 8, fig.

20."Test" the unit with the stove body pulled out. This

will allow you to see the motors in operation.

•Turn the control to the "OFF" position.

•Plug the unit into a 120 VAC 60 hz outlet.

•Turn the control to "test". All of the motors should

operate at full voltage for 60 seconds.

Note: The door must be closed for the feed motor to operate.

•With the "Test" completed, unplug the unit. 21. Inspect the flue docking gasket. See Fig. 36.

Docking Gasket

Everytime the unit is pulled out of the mounting frame, the orange high temperature docking gasket should be inspected. Check for tears or signs that the gasket is not sealing properly.

Docking Gasket

Hopper Seal

Inspect the silicone sponge hopper to top seal gasket. Look for tears or areas where the gasket may not seal properly to the bottom of the cast top. This only needs to be done when the top is removed. This is NOT nec- essary if the cast top is not removed. (Not part of any monthly, semi-annual or annual maintenance.)

Hopper seal gasket (gray or orange)

Fig. 36

Fig. 35