Section 6 - Operating the AL055 Economy Lift
Trunk Applications:
Operational Guidelines:
•Inspect the Lifting Strap prior to each use. Contact your distributor if it shows signs of wear or fraying.
•Do not operate this lift until you dealer has satisfactorily instructed you in the proper operation of this lift.
•Always make sure the vehicle’s parking brake is firmly set before operation.
•Keep hands and feet from under the scooter or power chair as it is being lifted.
•Take care not to hold one of the buttons on the Hand Controller until the Lifting Strap switches direction. The UP button should always pull the strap up and vice versa. If your buttons cause opposite movement, contact your distributor.
Loading your Scooter or Power Chair —Trunk Applications
Note: Due to the wide variety of scooters, power chairs and vehicles, your dealer may offer a different method for Loading and Unloading your scooter. Please follow the guidelines they have offered.
•To assemble your lift, begin by inserting the Post into the Base mounted on the floor. Next, slide the Lifting Arm onto the top of the Post.
•Plug the Hand Control into the lifting arm and into the Vehicle Harness.
•Swing the Lifting Arm out of the vehicle toward the scooter.
•Maneuver the scooter parallel to the rear bumper and two inches behind the vehicle. Depending on the vehicle, it may be necessary to: remove the seat; fold down or remove the handle bar; remove accessories such as brackets, baskets, crutch holders, etc.
•With the docking device positioned directly under the Strap Hook, lower the Lifting Strap using the DOWN button on the Hand Control until the Strap Hook can be engaged into the docking device installed on the scooter or chair. Hook the docking device on the scooter or chair with the Strap Hook and remove any play in the strap by pushing the UP button on the Hand Control until tension is felt.
Caution: Ensure that the Lifting Strap is secure and taught and that it points straight down. Failure to do so could result in the scooter or chair swinging toward the operator of the vehicle.
•Raise the scooter or chair using the UP button until the scooter or chair is just above the trunk lip.
Caution: Stop lifting before the Strap Hook contacts the Strap Roller mounted on the Lifting Arm. Contact will result in damage to the lift. A properly adjusted and operated lift will avoid this.
•Swing the scooter or chair into the vehicle, ensuring that the scooter or chair does not contact the vehicle.
•With the scooter or chair positioned above its stowed position, lower the lift using the DOWN button on the Hand Controller. Continue lowing the Strap Hook slightly beyond the scooter touching the floor to allow removal of the Strap Hook from the Docking Device on the scooter or chair.
•To disassemble the lift, first raise the strap until the freed Strap Hook is about an inch away from the Lifting Arm. Unplug the Hand Control harness from both the Vehicle Harness and the Lifting Arm.
•Pull the Lifting Arm off the Post and lay it on the floor of the trunk. Then, pull the Post out of the Base and set it down with the Lifting Arm.
18
