Hasselblad H1D user manual Cleaning with an e-wipe, Cleaning the housings

68

Hasselblad H1D

the filter only once. Do not wipe the same area twice with the same tissue as you might reapply dirt removed in the first sweep, potentially making things worse.

4.Finally check if the IR filter has been properly cleaned either by visual inspection or by mounting the camera back to the camera and making a shot. If further cleaning is needed, repeat cleaning procedure.

Cleaning with an e-wipe

E-wipes are individually packed wet tissues.

1.Tear at the notch to break seal.

2.Gently remove e-wipe from packaging and without delay begin cleaning procedure.

3.Fold the tissue to match the width of the surface to be cleaned.

4.Apply firm pressure using two or three fingers at the edge of the wipe to ensure evenly firm contact to filter surface - see Figure 10. Wipe surface in one unbroken motion. Note! Do not use same side of the e-wipe twice as you will be likely to reapply any particles removed in the first pass, potentially damaging the filter.

5.Finally check if the IR filter has been properly cleaned either by visual inspection or by mounting the camera back to the camera and making a shot. If further cleaning is needed, repeat cleaning procedure.

Cleaning the housings

If the sensor unit or Image Bank housings becomes dirty, clean them with a so, clean cloth lightly moistened with water only. Do not use any other solvents on the sensor unit. Do not allow water to get inside the devices.