Not For Resale – Free Download at
Troubleshooting
Your XPan II is a fully professional camera and should provide many years of service particularly if the advice is followed under 'Equipment Care, Service and Guarantee'. If a problem arises, however, check back in this manual to the relevant section first taking particular note of the specific warnings. Then check the table below to see if you can solve it. Refer to a Hasselblad Authorised Service Centre if the problem persists.
| Problem | Possible cause / solution |
|
|
|
|
Camera does not react when the release button is pressed.
You cannot attach the lens.
You cannot remove the lens.
New film has not wound on to first frame.
Whole film under/ overexposed.
Some frames unexposed.
•Mode selector in 'OFF7 position.
•Batteries omitted or exhausted.
•Ensure lens indexes are aligned.
•Depress lens release button while turning lens.
•Film tip incorrectly positioned before closing camera back.
•ISO setting to DX position with a
•Manual film speed (ISO) set incorrectly.
•Exposure compensation not set at zero.
•Lens cap not removed.
36