Hatco FDW-1-MN, FST-1-MN manual Installation, Set-Up

INSTALLATION

SET-UP

The Macho Nacho™ unit comes pre-assembled and ready for set-up.

1.Remove tape and protective film from all surfaces of unit.

2.Install the chip deflector inside, behind the upper door. See Figure 5.

3.Install decals on the upper front and side stainless steel panels.

Before installing decals, clean the stainless steel side panels with a non-oily cleaner, such as isopropyl alcohol (rubbing alcohol). After the cleaned surfaces have dried, simply remove the protective backing from the decal and apply to the panel. Any air pockets or bubbles behind the decal can be removed by rubbing gently with a soft cloth, working from the center of the decal towards the outer edges.

WARNING

For safe and proper operation, the unit must be located at a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur.

CAUTION

To prevent injury or damage the unit must be transported in the upright position. If laid on its side, all glass surfaces must be secured with tape.

CAUTION

Locate the unit at the proper counter height,

in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough

to support the weight of the unit and food displayed.

CAUTION

Unit is not weatherproof. For safe and proper operation locate the unit indoors where the ambient air temperature is a minimum of 70°F (21°C).

Install chip deflector in slots located behind upper door panel.

Chip Deflector

	Decal-Install on
	upper stainless
Floor Panels	steel panel.

Figure 5. Set-Up (FDW-1-MN shown)

Form No. MNM-0702 4