MAINTENANCE
GENERAL
Hatco Macho Nacho™ Chip Warmers are designed for maximum durability and performance, with minimum maintenance.
WARNING
To avoid any injury, turn the power switch
off at the fuse disconnect switch/circuit breaker or unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning.
CLEANING
To preserve the bright finish of the unit, it is recommended that the exterior and interior metal surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good stainless steel cleaner or a
CAUTION
Use only
Clean the glass using a common glass cleaner.
NOTE: For better access to the inside of the unit, the rear door panel assembly can be removed by loosening the thumbscrews on each side of the door panel assembly and lifting the assembly up and off. Be sure to tighten thumbscrews securely when installing the door panel assembly. See Figure 8.
DISPLAY LIGHT BULB REPLACEMENT
The display light is an incandescent light bulb which illuminates the warming area. The bulb has a special coating to guard against injury and food contamination in the event of breakage.
1.To replace a light bulb, disconnect the power supply and wait until the unit has cooled.
2.Bulbs have a threaded base. Unscrew the light bulb from the unit and replace it with a new specially coated incandescent bulb.
NOTE: Hatco
Thumbscrews (Two on each side)
HOLDING AND DISPLAY CABINET
Figure 8. Removing Door Panel Assembly
WARNING
Only light bulbs which meet or exceed N.S.F. standards, specifically designed for food holding areas must be used. Breakage of light bulbs not specially coated could result in personal injury and/or food contamination.
WARNING
If service is required on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at
or
WARNING
This product has no “user” serviceable parts.
To avoid damage to the unit or injury to personnel, use only Authorized Hatco Service Agents
and Genuine Hatco Parts when service is required.
WARNING
Genuine Hatco Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn.
Form No. | 6 |
