ASSEMBLY
Glo-Ray®Strip Heaters are shipped with most components pre-assembled. Dual units are available with a required 3" (76 mm) or 6" (152 mm) spacer pre-assembled at the factory.
Optional breath protectors, mounting equipment and remote control enclosures must be installed on location.
PORTABLE SURFACE MOUNT
T-Leg Stand
NOTE: T-Leg not to be used with dual Glo-Ray units.
NOTE: T-Leg stands available in standard wattage - 10" (254 mm), high wattage - 13-1/2" (343 mm), 16" (406 mm), and 18" (457 mm).
1.Position the unit upside-down on a flat surface.
2.Remove the two screws and mounting tabs from each end of the unit.
3.Position the mounting bracket on the underside of the unit and remove the two screws on the unit that match up with the holes on the mounting bracket.
4.Secure the mounting bracket to the unit with the previously removed screws.
5.Align two mounting holes on side of T-Leg with two holes on end of unit and attach leg with screws supplied.
6.Align the mounting hole on the T-Leg bracket with the hole on the mounting bracket and secure with a screw. (See Figure 13.)
C-Leg Stand
NOTE: C-Legs are not to be used with dual Glo-Ray models.
NOTE: Two types of C-Legs are available. CL-Low, 10" (254 mm) clearance, is for standard wattage Glo-Ray models up to 6 ft. (1829 mm) in width only. CL-High, 13-1/2" (343 mm) clearance, is for high wattage Glo-Ray models up to 6 ft. (1829 mm) in width only.
1.Position the unit upside-down on a flat surface.
2.Remove the two screws and mounting bracket from each end of the unit.
