•Reinstall the reflector, and align it properly. Clean the reflector if necessary with
•Clean the glass lens, and place it on top of the reflector. The glass will directly hold the reflector in place.
•Wrap the lens gasket around the housing and lens. The gasket will hold the lens and fixture together. Ensure it is clean and placed properly before proceeding.
•Replace the lensframe by first pressing one end into the lens gasket. Make sure the tab is oriented properly before pressing it in firmly. Start pressing at the tab, and work the lensframe into the gasket by pressing firmly every couple of inches along the lensframe until the entire lensframe is seated properly. It is important to press in sequence, starting from the first tab and working all the way around the lensframe. The last place to press is the second tab, and the two lensframe tabs should meet closely when the lensframe is installed properly. Replace the lensframe screw and nut, and tighten them securely.
Caution: Do not touch the glass bulb of the lamp. If necessary, clean with isopropyl alcohol.
3.Troubleshooting:
•In the event of improper operation, first use a voltmeter to ensure that the fixture is receiving adequate input power.
•If no electrical faults are found, then either the ballast or lamp may require replacement. Always replace the lamp first, especially if it is an old lamp.
•If the fixture fails to light after replacing the lamp, then replace the ballast as well.
•A new lamp should normally be installed whenever a new ballast is installed.
•If necessary, contact
