OPERATION
HOW TO USE THE
TRIMMER HEAD DRIVE LEVER
1.To engage the trimmer head, hold the con- trol bail against the handle. Move the trimmer head drive lever forward to en- gage the trimmer head. See Figure 6. The faster the engine runs, the faster the trim- mer head will rotate.
2.Once the trimmer head is rotating, push the machine forward to trim.
Control Bail |
Handlebar |
Trimmer Head |
Drive Lever |
Figure 6 |
HOW TO USE THE
THROTTLE CONTROL
1.During normal use, set the throttle con- trol lever in the FAST position to run the engine at full speed.
2.Pull the throttle control lever back to de- crease engine speed. Push the throttle control lever forward to increase engine speed.
3.To stop the engine, pull the throttle con- trol lever completely back to the STOP position.
Throttle Control |
Lever |
Figure 7 |
HOW TO USE
THE PRIMER BUTTON
1.Push the primer button. See Figure 8 for location. For the number of times to push the primer button, see the primer button decal located on the engine or follow the directions in the Engine Manual. Wait approximately two seconds between each push.
NOTE: Do not use the primer button to re- start a warm engine after a short shutdown.
Primer Button |
Figure 8 |
12 |
