ASSEMBLY
HOW TO RAISE THE HANDLE
1.Hold the handle with one hand and loosen both handle adjustment knobs until the ratchet teeth are disengaged. Do not remove the handle adjustment knobs. See Figure 2.
2.Raise the handle to the
operating position. |
| ||
3. Stand in the operator’s | Handlebar | ||
position behind the ma- | |||
| |||
chine. Put the handle in |
| ||
a comfortable position. | Rope | ||
Make sure both sides of | |||
Guide | |||
the handle are level. | |||
| |||
NOTE: Make sure the |
| ||
cables are not caught | Recoil Start | ||
between the upper and | |||
Handle | |||
lower handle. | |||
Handlebar | |||
4. Tighten the handle ad- | |||
Pivot | |||
justment knobs. Make | |||
| |||
sure the handle pivots |
| ||
are locked in place. | Handlebar | ||
NOTE: The handlebar | |||
Adjustment Knob | |||
height is | adjustable. |
| |
See “How | To Adjust |
| |
The Height Of The Han- |
| ||
dlebar” in the Mainte- |
| ||
nance section. | Figure 2 | ||
5.To attach the recoil start handle to the rope guide, twist the rope through the rope guide mounted on the right side of the handlebar.
HOW TO ATTACH THE GUARD
1.Attach the guard to the machine with the four fasteners as shown. See Figure 3.
Fastener Trimmer
Guard 
Figure 3
9 |
